Eltako 23100832 TDR DIN rail 8 V DC/AC, 12 V DC/AC, 24 V DC/AC, 110 V DC/AC, 230 V DC/AC

1 closing contact not isolated 16 A/250 V/AC, incandescent bulbs up to 2300 W, ESL and LED-lamps up to 200 W. control voltage 230 V and/or 8..230 V UC. Switch-off pre-warning and scanner light can be attached. Stand-by-loss only 0.7 W. With ESL-optimization and multi-function. Number of built-in device for mounting on support rails DIN-EN 60715 TH35. 1 division unit = 18 mm wide, 58 mm deep. Contact switching in the zero crossing to protect the contacts and lamps. In particular, this extends the life span of energy-saving lamps. The noiseless electronics bothered not the Prioritises ndlichste ear - completely contrary to many synchronous motors with mechanical transmission.Through the use of a bi-stable relay, there are also when it is switched on, no coil power loss and no heat build-up in this way. After installing the automatic short synchronization wait before the consumer connected downstream of the power. Control-, supply and switching voltage 230 V. in addition with galvanically isolated universal control voltage 8..230 V UC. For 3- and 4-wire circuits, Resetteable, with roof floor lighting for 4-wire circuit. Automatic detection of the type of connection.Glow lamp current up to 50 mA, depending on the starting voltage of the glow lamps. Exact time adjustment 1 to 30 minutes with minute scale.Continuous light switch with the big rotary switch. After a power failure in the function setting TLZ is the lightSwitched on when the time is not yet complete. With double connections for buttons and lamp, so that either the top and bottom or bottom only can be connected. The light flickers at trains = unconnected switch-off pre-warning about 30 seconds beforeStarting time and a total of 3 times in shorter time intervals. With added scanner light can be button for longer than 1 sec. for continuous light, which is turned off automatically after 60 min or with buttons for more than 2 seconds can be switched off. Are scanner light and switch-off pre-warning, takes place after switching off the continuous light only the switch-off pre-warning. Be wholly or partially energy saving lamps ESL connected, then the switch-off pre-warning and scanner light on the right-hand side of the rotary switch. ESL Within the first second after switching on or after can switch in the tlz functions the time by up to 3 times short keys can be extended. Each keys added 1 times the set time. With multi-function: can be switched to the functions it (relay), HE (relay) and ESV (Surge switch with fall-back delay). In the function ESV correspond to the central rotary switch at pre-set times (t) the following values: 1 = 2 min, 2 = 5 min, 3 = 10 minutes, 4 = 15 minutes, 6 = 25 minutes, 8 = 35 min, 10 = 45 min, 12 = 60 min, 20 = 90 min, 30 = 120 Min. After the set delay time is automatically switched off when the manual off command not been given. Switch-off pre-warning and scanner light are also ESV can be activated. Forgetting to continuous light is switched off after 2 hours.This text is machine translated.

Price: £ 49.99 from Conrad Electronic